DH Templates

Microsoft Power Point Question! 10 Points Best Answer!?

How do I apply an animation template so that all animations and slide changes are done automatically, even if they're lame and all the same...I already have a design formation applied but for some reason it doesn't include animations, only backgrounds and type...thanks! *I think I'm using powerpoint 2003 or 2005, it's relatively old... I promise to award 10 points to the best answer!!

Public Comments

1. Well l have Power Point 2003 too. lf you want for all your slides to make the transition automatically just follow this steps. Open Power Point go to the left where those little squares are. Right click on the very fist one. Select Slide transition. Now look to your right. At the lower part of the screen you are going to find Advance slide. You need to uncheck On mouse click. lf you have the check mark on that box it means the slides are going to move only if you use the mouse to click. Now that it is unchecked, you see a little square under it? Next to it you see........Automatically after. That is the time you are going to give to each slide before it lets the next one show up, so you decide for how many seconds you want each slide displayed before it automatically closes. If you want for all your slides to last the same amount of time, type the amount of seconds inside that little box and then click apply to all slides. But if you like for some slides to last longer than others then you give some of them more time, that is mainly where there is a lot of written messages on the slide, then you need to do the process individually to each slide. Hope this helps. Good luck!